DRAGONFIRE 04-0045 User Manual

DragonFire
Slayer Sport Side Mirrors
Part # 04-0045 Multiple Vehicles
Congratulations on your purchase of DragonFire Racing Sport Side Mirrors! Now YOU can check on your buddies eating your
dust with the stylish side mirrors. Adjustable and off-road ready.
Disclaimer
Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty of representation is made as to the products
ability to protect the user from any injury or death. The user assumes that risk. The acceptance and /or use of this merchandise purchased from DragonFire by
the customer hereby shall release DragonFire from any and all liability pertaining to the use of such merchandise.
• Read and understand these instructions before installing product
• Installation may scratch powder coat or paint
• Improper installation may result in unsatisfactory viewing angle
• Do not use product if there are any signs of damage
Tools Required
4mm Allen Bit or Wrench
Ratchet
Pre-installation: Lay out components and compare to list and images.
Part & Hardware List
ITEM QTY SIZE LENGTH TYPE STEP USED
P1 1 - - Slayer SS Mirror LH* All
P2 1 - - Slayer SS Mirror RH* All
P3 2 - - Rubber Pad Insert 4
P4 2 - - Indicator Disk (Extra)
*
Driver and Passenger Mirror will be determined by the logo in the correct orientation.
P1
P2
P3
Note: An assistant may be needed to hold the product in place during installation.
P4

DRAGONFIRE 04-0045 Specifications

General

Brand	DRAGONFIRE
Model	04-0045
Category	Automobile Accessories
Language	English

Summary

Safety Warning

Product Installation Hazards

Read and understand instructions before installing. Installation may scratch powder coat or paint. Improper installation may result in unsatisfactory viewing angle. Do not use if damaged.

Product Disclaimer

Assumption of Risk

Off-road activities are hazardous. No warranty is made as to product ability to protect user from injury or death. User assumes risk.

Pre-installation and Component Check

Part and Hardware List

Lay out components and compare to the provided list and images to ensure all parts are present before installation.

Installation Steps

Vehicle Preparation

Place the vehicle on a flat, level surface, set gear selector to 'Park', and remove keys from ignition.

Mounting the Mirror

Remove bolts from mirror mount, place mirror and clamp band onto vehicle frame, and loosely tighten bolts.

Securing the Mirror Clamp

Place rubber pad insert, tighten the middle bolt until clamp is secured, then tighten side bolts until secure.

Adjusting Mirror Position

Loosen middle bolt slightly to rotate mirror to desired position, then retighten middle bolt until secured.

Final Check and Repetition

Check all bolts are securely tightened. Repeat installation for the opposite side mirror.