Step 3: Remove the two bolts and two
pushpins from front “A” pillar step through.
Two bolts and one pushpin will be re-
used. (See Figure B)
Step 4: Remove U-Nut located behind plastics in the second hole down location. Re-
locate this to the third hole down behind plastics. (See Figure C & D)
Step 5: Using 3/8” drill bit enlarge 2
nd
hole
down, this is the same hole U-Nut was
removed from. (See Figure E)
Step 6: Install new supplied U-Nut behind
plastics of previously drilled hole. (See
Figure F)
Dragonfire Racing
To Next Page
Loading...