Draminski GMM - Resetting to Factory Settings

19CHAPTER 4 | DATA MODIFICATION
EN
You can leave the modication mode by turning off
the power supply.
ATTENTION!
The name for which the modication has been
made, is marked with „*” sign.
2. ERASING MODE:
This operation restores the factory settings for the
chosen sample name (it removes all the correc-
tions for one species).
To select ERASE DATA, hold down the „CAL/cancel”
key and turn on the power with the „ON/OFF” but-
ton, then press the  „UP” button and accept the
ERASE option by pressing the „OK” button.
After you’ve accepted the password in the modica-
tion mode menu the name of the last tested sample
will appear. That can be changed using  or 
After you’ve accepted the selected name the „OK”
message will appear. At this point all adjustments will
be removed. The „*” symbol will be also removed
with the previously modied type of grain.
The „OK” message will appear and all adjustments
will be removed. The „*” symbol will be also removed
with the previously modied type of grain.
Pressing „CAL/
CANCEL” will cause the canceling of this
operation and the information „CANCEL” will be dis-
played. You can leave the modication mode by turn-
ing off the power supply.