5. HEALTH & SAFETY INFORMATION
5.2 TRANSFORMERS/BATTERY
CHARGERS
a. For indoor use only. Do not expose to rain.
b. If the cord is damaged the transformer shall be
scrapped.
c. If the non-self-resetting protective device is
activated due to short circuit or an overload
the transformer shall be scrapped.
d. The fail-safe safety isolating transformer
converts by means of electromagnetic
induction, alternating voltage (230V) into
another system of voltage (3.6V) for the sole
purpose of recharging the Draper 3.6V
screwdrivers. Any other application is
considered misuse.
e. Before charging, read the instructions.
f. Disconnect the supply before making or
breaking the connections to the battery.
g. Do not charge non-rechargeable batteries.
h. This transformer charger is only suitable for
charging rechargeable lithium-ion batteries
having one cell (3.6V). Any other application is
considered misuse.
5.3 BATTERY
a. The battery must be removed from the
appliance before it is scrapped.
b. The appliance must be disconnected from the
supply mains when removing the battery.
c. The battery is to be disposed of safely.
d. Do not use non-rechargeable batteries.
e. Do not crush, open or burn the battery.
Exposure to potentially harmful materials may
occur.
f. In case of fire use CO2/dry chemical
extinguisher.
g. Do not expose to high temperatures ≥ 50°C.
Cells may degrade at high temperatures.
h. The battery must be charged by a constant
current, constant voltage transformer.
i. Charge battery regularly in conditions
between 5°C to 45°C with the specified
charger designed for this battery.
j. Store in a dry, well ventilated area within the
recommended limits of 5° to 30°C.
k. During decommissioning remove the battery
cell for recycling separately to the product,
which is covered by the waste electrical and
electronic equipment directive. Insulate the
terminals with adhesive insulating tape to
prevent a short circuit, fire or explosion
occurring.
5.4 LITHIUM-ION MATERIAL DATA
SHEET
a. As a substance under normal conditions of use
it is not considered a hazard to health. In the
event of accidental release, measures to
prevent spread must be adhered. Do not
contaminate rivers, waterways or drains.
b. Composition of lithium-manganese,
lithium-colbalt and lithium salt as the organic
solvent electrolyte (nonaqueous liquid).
c. Hazardous Decomposition: None during
normal operating conditions. If cell is ruptured
hydrogen fluoride and carbon monoxide may
be released.
5.5 FIRST AID RECOMMENDATIONS
– In case of ingestion: If swallowed, obtain
medical attention immediately.
– In case of contact with eyes: Thoroughly flush
eyes with clean water for 15 minutes and seek
medical attention immediately.
– In case of contact with skin: Wash area with
soap and water. If irritation persists, seek
medical advice.
– Other: Seek medical advice immediately.
5.6 CONNECTION TO THE POWER
SUPPLY (TRANSFORMER)
– no noitamrofni ylppus rewop eht erus ekaM
the machine’s rating plate are compatible with
the power supply you intend to connect it to.
– KU a htiw deilppus semoc revirdwercs sihT
standard 3 pin transformer. It is designed for
connection to a domestic power supply rated
at 230V AC.
– ;)detalusni elbuod( 2 ssalC si tI is designed for
connection to a power supply matching that
detailed on the rating label and compatible
with the plug fitted.
– If an extension lead is required, use an
approved and compatible lead rated for this
appliance. Follow all the instruction supplied
with the extension lead.
– sa noitcennoc htrae on seriuqer tcudorp sihT
supplementary insulation is applied to the basic
insulation to protect against electric shock in
the event of failure of the basic insulation.
7
To Next Page
Loading...