ASSEMBLY
OPERATION AND USE
NOTE:
Remove the plug from the power supply
before carrying out adjustment, servicing or
maintenance.
NOTE:
This machine will not function without the use
of a solid wall suction hose kit.
Connect the suction hose (A) into the suction
inlet (B). Fig.1.
For suction hose see optional accessories
(page 9).
Connect the elbow (C) into the outlet (D)
and secure an outlet hose (E) to the elbow
(C) using a suitable hose clip. Fig.2.
Before operating the pump for the first time, it
should be primed with water through the
suction inlet, the filling operation must be
carried out very slowly. Ensure that the water
level is to the maximum. Fig.3.
Submerse the filter (F) attached to the end of
the solid wall suction hose (sold separately)
before turning the pump on. Press swich (G)
into the 'on' position. Fig.4.
NOTE: If after 1-2 minutes the pump is not
pumping water, switch off and repeat the
priming operation. Fig.3.
- 6 -
Fig.1.
(B)
(A)
Fig.2.
(C)
(D)
(E)
Fig.3.
Fig.4.
(G)
(F)
To Next Page
Loading...
