8
Turning the Power On
1 Insert the plug of the Power Cord into the DC IN connector on the back of the
balance.
2 Connect the Power Cord to the power outlet.
3 Press “ON”.
The display will automatically go through the changes indicated below.
Warming Up
Before performing span calibration on the balance or measuring its accuracy,
you must ensure that is it in a stable state.
When stabilizing the balance, it is important that its temperature is stable.
Putting the balance in weighing mode and leave it with the power on for at
least half an hour in advance of calibration.
This is called “warming up”.
Performing Span Calibration
Always perform span calibration for a balance after moving it. Weights are
required for external calibration balances.
Before performing span calibration, warm up the balance in advance.
To Next Page
Loading...