Need help?Do you have a question about the Drawmer DL241 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Input Connectors | XLR, 1/4" TRS |
| Output Connectors | XLR, 1/4" TRS |
| Sidechain | Yes |
| Compression Ratio | 1:1 to ∞:1 |
| Controls | Threshold, Ratio, Attack, Release, Bypass |
| Frequency Response | 20 Hz to 20 kHz |
| THD + Noise | < 0.05% |
| Signal to Noise Ratio | >90dB |
| Dynamic Range | > 100 dB |
| Sidechain Filter | High-pass filter |
| Power Supply | 115/230V AC, 50/60Hz |
| Dimensions | 482 x 44 x 200 mm |
Replace fuses with correct type; do not tamper with mains cable.
Refer servicing to qualified personnel; avoid exposure to rain or moisture.
Caution against electric shock and opening the unit.
Dual channel compressor/limiter with expander and peak limiter for studio and live sound.
Combines ratio and soft-knee approaches for flexible level control.
Programme Adaptive expander reduces noise during pauses without affecting wanted sounds.
Sets an absolute output limit for fast peak control and creative effects.
Designed for 19" rack mounting, occupies 1U; advice on heat and washers.
Details balanced/unbalanced wiring for jacks and XLR, and operating level selection.
Advice on managing interference and ground loop issues for optimal audio quality.
Procedure to change mains voltage via rear panel switch and replace the fuse.
Explains the Expander Threshold and Release controls for setting up gating action.
Sets input level for gain reduction and the final compression ratio.
Monitoring gain reduction and setting compressor response and recovery times.
Utilizing auto optimization for attack/release and adjusting output gain.
Monitors output signal level and enables a hard-wire bypass of processing.
Sets an absolute output limit to prevent peaks without distortion.
Configures stereo mode where left channel controls act as masters for both channels.
Connecting the unit and initial setup for single channel or stereo link modes.
Setting Threshold, Ratio, Attack, and Release for optimal compression.
Setting expander threshold and gain control for desired output level.
Setting peak limiter and effectively bypassing compressor/limiter functions.
Procedure for reporting faults and obtaining warranty service.
Information for application questions and technical help line.
Specifications for input/output impedance, level, and frequency response.
Measured noise at unity gain and distortion across different frequencies.
Details power consumption, fuse ratings, case size, and weight.
Visual representation of signal paths through the unit's channels and modules.
To Next Page