Draytek Vigor 2763 Series - Page 7

3
Interface
Description
WLAN
ON / OFF /
WPS
Press for less than 2 seconds to switch toggle the router’s
wireless interfaces:
For example,
⚫ 2.4G (On) and 5G (On) – Default state.
⚫ 2.4G (Off) and 5G (On) – press and release the button once.
⚫ 2.4G (On) and 5G (Off) – press and release the button twice.
⚫ 2.4G (Off) and 5G (Off) – press and release the button three
times.
When WPS is enabled in the router’s web interface, press this
button for more than 2 seconds to enable WPS pairing mode.
Factory
Reset
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press gently and
hold for more than 5 seconds. When the ACT LED blinks rapidly,
release the button. Then the router will restart with the factory
default configuration
USB1~USB2
Connector for a USB 3G/4G modem, storage, printer or USB
Thermometer
P1~P4
RJ-45 Gigabit Ethernet connectors for local network devices.
LAN port P4 can be configured as the Ethernet WAN port, see:
https://www.draytek.co.uk/support/guides/kb-ethernetwan-enable
DSL
RJ-11 connector for ADSL or VDSL line
I/O
Power Switch. Turns the unit on (I) or off (O)
PWR
Connector for the power adapter