Draytek Vigor2760 Delight - User Manual

www.draytek.net.nz
www.snappernet.co.nz
Vigor2760 Delight » Quick Start Guide
Configure your computer’s network
Connect your computer to the Vigor2760 with an Ethernet cable (supplied). Ensure your computer is obtaining an IP
address automatically.
Connect to the Web Interface
Open your Web Browser (e.g. Internet Explorer, Google Chrome or Mozilla Firefox), enter http://192.168.1.1/ into
the address bar, and press the Enter key on your keyboard.
You should be asked for a username and password. Enter admin into both fields (the password may show as dots or
stars) and click the Login button.
Run the Quick Start Wizard
On the left-hand navigation menu, click Wizards and then Quick Start Wizard.
Choose a new login password - you will use this to log into the Web Interface in
future. Enter the current password (admin) into the Old Password field. Enter your
new password into the New and Confirm Password fields and click Next >
Note: The passwords may show as dots or stars
In the WAN Interface section you can leave all settings as default unless you are connecting to VDSL on a Chorus
line in which case you must enable VLAN Tag insertion and set the Tag value to 10, then click Next >

Summary

Initial Setup and Web Interface Access

Connect to Web Interface

Access the device's web interface by entering its IP address in a browser.

Run Quick Start Wizard

Use the Quick Start Wizard to configure basic settings, including the WAN interface.

Internet Connection Configuration

Configure ISP Connection

Set protocol, encapsulation, VPI/VCI, and ISP credentials for internet access.

Verify Connection Status

Check WAN status for IP and GW IP assignment after configuration.

Draytek Vigor2760 Delight Specifications

General

LAN Ports	4 x Gigabit Ethernet
Firewall	Yes
WAN Connection Type	ADSL2+
Maximum Wireless Speed	300 Mbps
USB Ports	USB 2.0
WAN Ports	1 x RJ11