What to do if USB LED lights on but the network connection does not work on my Draytek Network Router?
If the USB LED is lit but the network connection isn't working, the SIM card's PIN code may be enabled. Disable the PIN code using the 3G/4G USB Modem utility and try again.
Why WAN connection cannot be up on Draytek Vigor2762?
If the WAN connection isn't working, verify that the settings provided by your ISP (Internet Service Provider) are configured correctly.
What to do if I cannot access the Internet after installing Draytek Vigor2762?
If you cannot access the Internet after installing the router, check your basic installation status stage by stage, following the relevant sections.
What to do if Draytek Vigor2762 Network Router did not respond to ping requests?
If the router isn't responding to ping requests, check the IP address setting of your computer.
What to do if the network connection settings on your computer are not OK for Draytek Vigor2762 Network Router?
If the network connection settings on your computer are not correct, select 'Obtain an IP address automatically' and 'Obtain DNS server address automatically'.
What to do if USB LED does not light on after inserting 3G/4G USB Modem into Draytek Vigor2762?
If the USB LED doesn't light up after inserting the 3G/4G USB Modem, remove and reinsert the modem.
What to do if the hardware status is not OK on Draytek Vigor2762?
If the hardware status is not OK, redo the hardware installation.
General| Product Series | Vigor2762 Series |
|---|---|
| Category | Router |
| LAN Interfaces | 4 x Gigabit Ethernet |
| Wireless Standards | IEEE 802.11a/b/g/n/ac |
| Wireless Frequency Bands | 2.4 GHz & 5 GHz |
| Firewall | SPI (Stateful Packet Inspection) Firewall, DoS/DDoS protection |
| VPN Support | IPSec, PPTP, L2TP |
| Power Supply | 12V DC |
| Management | CLI |
| VoIP | Yes (on 'V' models) |
To Next Page
