Web User Interface
Web User Interface
IV-1-1
IV-1-1
Remote Access Control
Remote Access Control
Enable the necessary VPN service as you need. If you intend to run a VPN server inside your
LAN, you should disable the VPN service of Vigor Router to allow VPN tunnel pass through,
as well as the appropriate NAT settings, such as DMZ or open port.
After finishing all the settings here, please click OK to save the configuration.
IV-1-
IV-1-
2
2
PPP General Setup
PPP General Setup
This submenu only applies to PPP-related VPN connections, such as PPTP, L2TP, L2TP over
IPsec.
Available settings are explained as follows:
Vigor2762 Series User’s Guide
To Next Page
Loading...
Need help?
General
