Next Click it to get into the next setting page.
Cancel Click it to give up the quick start wizard.
2. Please type in the IP address/mask/gateway information originally provided by your
ISP. Then click Next for viewing summary of such connection.
3. Click Finish. A page of Quick Start Wizard Setup OK!!! will appear. Then, the system
status of this protocol will be shown.
4. Now, you can enjoy surfing on the Internet.
I-6-2 For WAN2 (Ethernet)
I-6-2 For WAN2 (Ethernet)
WAN2 is dedicated to physical mode in Ethernet. Please select the appropriate Internet
access type according to the information from your ISP. For example, you should select
PPPoE mode if the ISP provides you PPPoE interface.
Available settings are explained as follows:
Vigor2762 Series User’s Guide
To Next Page
Loading...
Need help?
General
