activated always.
If you choose Failover as the Active Mode, the option of
Active When will appear.
Failover – Choose it to make the WAN connection as a
backup connection.
WAN Failure – When the active WAN failed, such WAN
will be activated as the main network connection.
Traffic Threshold – When the data traffic of active
WAN reaches the traffic threshold (specified here),
the failover WAN will be enabled automatically to
share the overloaded data traffic.
After finished the above settings, click OK to save the settings.
II-1-1-3 WAN3 / WAN4 (USB)
II-1-1-3 WAN3 / WAN4 (USB)
To use 3G/4G network connection through 3G/4G USB Modem, please configure WAN3 or
WAN4 interface.
Available settings are explained as follows:
Item Description
Enable Choose Yes to invoke the settings for this WAN interface.
Choose No to disable the settings for this WAN interface.
Display Name Type the description for such WAN interface.
Physical Mode Display the physical mode of such WAN interface.
Line Speed If you choose According to Line Speed as the Load Balance
Mode, please type the line speed for downloading and
uploading for such WAN interface. The unit is kbps.
Active Mode Choose Always On to make the WAN connection being
activated always.
If you choose Failover as the Active Mode, the option of
Active When will appear.
Failover – Choose it to make the WAN connection as a
backup connection.
Vigor2762 Series User’s Guide
To Next Page
Loading...
Need help?
General
