Extension WAN – Not only the IP address can be obtained
from the primary WAN, but also the prefix for IPv6 LAN IP
address can be assigned by extension WAN specified here.
When you finish the configuration, please click OK to save and exit this page.
II-2-1-3 Details Page for LAN2
II-2-1-3 Details Page for LAN2
Available settings are explained as follows:
Item Description
Network Configuration Enable/Disable - Click Enable to enable such configuration;
click Disable to disable such configuration.
IP Address - Type in private IP address for connecting to a
local private network (Default: 192.168.1.1).
Subnet Mask - Type in an address code that determines the
size of the network. (Default: 255.255.255.0/ 24)
DHCP Server
Configuration
DHCP stands for Dynamic Host Configuration Protocol. The
router by factory default acts a DHCP server for your
network so it automatically dispatch related IP settings to
any local user configured as a DHCP client. It is highly
recommended that you leave the router enabled as a DHCP
server if you do not have a DHCP server for your network.
Enable Server - Let the router assign IP address to every
host in the LAN.
Disable Server – Let you manually assign IP address to every
host in the LAN.
Enable Relay Agent - If you want to use another DHCP
server in the network other than the Vigor Router’s, you can
let Relay Agent help you to redirect the DHCP request to
the specified location.
DHCP Server IP Address – It is available when Enable Relay
Agent is checked. Set the IP address of the DHCP server you
are going to use so the Relay Agent can help to forward the
DHCP request to the DHCP server.
Start IP Address - Enter a value of the IP address pool for
Vigor2762 Series User’s Guide
To Next Page
Loading...
Need help?
General
