EasyManuals Logo

Draytek Vigor2862 Series Quick Start Guide

Draytek Vigor2862 Series
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
4
LED
Off The port is connected with 10/100Mbps
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
WAN2
Right
LED
Off The port is connected with 10/100Mbps
Switch on Rear Side
Interface Description
Factory Reset
Restore the default settings. Usage: Turn on the router
(ACT LED is blinking). Press the hole and keep for more than
5 seconds. When you see the ACT LED begins to blink
rapidly than usual, release the button. Then the router will
restart with the factory default configuration.
DSL / DSL 1/2
Connecter for accessing the Internet.
LAN (1-4)
Connecters for local network devices.
WAN2
Connecter for local network devices or modem for
accessing Internet.
USB1~2
Connecter for a USB device (for 3G/4G USB Modem or
printer or thermometer).
PWR Connecter for a power adapter.
ON/OFF Power Switch.

Other manuals for Draytek Vigor2862 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Draytek Vigor2862 Series and is the answer not in the manual?

Draytek Vigor2862 Series Specifications

General IconGeneral
BrandDraytek
ModelVigor2862 Series
CategoryFirewall
LanguageEnglish

Related product manuals