How to fix link failure due to wrong network connection settings on Draytek Vigor2860 Firewall?
Select 'Obtain an IP address automatically' and 'Obtain DNS server address automatically' in your network settings. Then, click OK.
How to improve wrong connection by returning to the default settings on Draytek Firewall?
Try to reset the Draytek router by software or hardware.
What to do if WAN connection cannot be up on Draytek Vigor2860 Firewall?
If the LEDs are off, try changing the Physical Type from Auto negotiation to other values, such as 100M full duplex. Also, ensure your ISP settings are configured correctly by opening the WAN >> Internet Access page and reviewing the settings you configured previously. If the LEDs problem persists, consider installing an additional switch for connecting both the Draytek router and the modem offered by your ISP. Check if the LEDs on the Draytek router are then on.
What to do if USB LED lights on but the network connection does not work on Draytek Vigor2860 Firewall?
Check if the PIN Code of your SIM card is disabled. Use the utility of your 3G/4G USB Modem to disable the PIN code and try again.
What to do if the USB LED does not light on after inserting 3G/4G USB Modem on Draytek Firewall?
Remove and reinsert the modem again. If it still fails, restart the Draytek device.
What to do if having hardware status issues on Draytek Vigor2860 Firewall?
Simply go back to 'I-2 Hardware Installation' and execute the hardware installation again. Then, try again.
To Next Page
General