Dream H12 - Care & Maintenance; General Maintenance Tips; One-Touch Self-Cleaning Function

13 14
EN EN
Care & Maintenance
Cleaning the Brush Roller Cover
1. Press the brush roller cover release
buttons at both ends inward to remove
the cover
2. Rinse the cover with clean water or
wipe it with a cloth.
* Clean it as needed.
3. Dry the cover completely before use. 4. Re-install the cover back.
1
2
1
2
Care & Maintenance
Cleaning the Brush Roller
1. Press the brush roller release button,
and the brush roller handle pops out.
Pull it to take out the brush roller.
2. Clean outanyhair and debris
tangled on the brushrollerwith the
provided cleaning brush. Rinse the
brushrollerwith clean water and dry it
completely.
3. Wipe the suction inlet with a dry cloth
or wet tissue. Do not rinse the brush
assembly with water.
4. After cleaning the brush roller , align
and pushtheright end into the right slot
on the brush assembly and press the
brush roller handle into the left slot on
the brush assembly.
* Clean it as needed. Replacing every 3 to 6 months is recommended.