Dreame V12 - Cleaning the HEPA Filter Assembly

17
EN EN
Care & Maintenance
Cleaning the HEPA Filter Assembly
1. Place the vacuum securely on a 󽗊at surface, then turn the HEPA 󽗉lter assembly cover in
the direction indicated and remove the HEPA 󽗉lter assembly.
Note: Remove the built-in foam pad before cleaning the HEPA 󽗉lter assembly.
Note: Fully dry the 󽗉lter (at least 24 hours) before reinstalling it.
2. Rinse the HEPA 󽗉lter and foam pad with water. To thoroughly remove all the dust caught
in the 󽗉lter, rotate the HEPA 󽗉lter 360 degrees while rinsing. Lightly tap the 󽗉lter against
a sink several times to remove any excess debris. Keep the HEPA 󽗉lter in a well-ventilated
and cool place to fully dry.
3
12
6
111
57
210
48
9
24 hrs
1
2
3