Dreamline FLEX Series - Installation Steps; Initial Frame Assembly

© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
Installation steps
7
FLEX 42x72 48x72 54x72 60x72 60x58 Shower and Tub Door manual Ver 1 Rev 4 072019
©2019 DreamLine. All Rights Reserved
60” model
◾SHDR-22427200-01 / SHDR-22487200-01 / SHDR-22547200-01: Insert the end that is closer to
the pivot hole
◾SHDR-22607200-01: Insert the end that is farther from the pivot hole
!
!
Fig 1
top
bottom
outside inside
outside inside
pivot
hole
Right hand door installation shown
door
pivot
hole
insert
this end
42” and 48” model
door
23-5/8”
23-5/8”
Insert the correct end of
the pivot rail based on the
model size. (See below)
*The pivot hole is very close to center
on the 54” model size. Double check
the dimensions before inserting the rails
54” model*
23-5/8”
23”
pivot
hole
pivot
hole
insert
this end
insert
this end
1. Insert the Top & Bottom Pivot Rails (#15) into the expandable rails of the Stationary panel
Assembly (#02). (Fig 1)