40
OPERATION & USE
Ionizer
• The chair is equipped with an air Ionizer that purifies the air. Turn the Ionizer on by, if not already there, pressing the
Home/Menu button to access to the Main Menu. Then use the navigation arrows to navigate to Settings, scroll right
to access Ionizer, then press OK to turn the Ionizer on. Press again to turn the Ionizer off. When on, a green dot will
appear to the right of the listing, when off, the dot remains clear.
Sound
• The remote can be set up to either beep or remain silent with each button press. To change the Sound setting, if not
already there, press the Home/Menu button to access to the Main Menu. Then use the navigation arrows to navigate
to Settings, scroll right to access Sound, press OK to turn the Sound on. Press again to turn the Sound off. When on,
a green dot will appear to the right of the listing, when off, the dot remains clear.
NOTE: The default setting is Sound Off.
LED Lights
• For safety and tranquility, the chair is equipped with lights located on each arm. These can be set to Sensing
mode which turns the lights on with motion activation, On mode which leaves the lights on indefinitely, and Off
mode which makes it so the lights always remain off.
• To change the LED Light setting, if not already there, press the Home/Menu button to access to the Main Menu.
Then use the navigation arrows to navigate to Settings, scroll right to access Nightlight modes. Once desired setting
is highlighted, press OK to select. A green dot will appear to the right of the selected mode.
NOTE: The default mode is Sensing
NOTE: When in sensing mode, the lights will turn on when motion is detected near the chair. They will remain on for
90 seconds, at which point they will turn off unless reactivated with new motion.
NOTE: Night lights, in all modes, will only remain active for eight hours after remote power is turned off.
Chromotherapy
• For additional sensory relaxation, the remote is programmed to be able to display chromotherapy sessions when
powered on and the remote has been idle for 90 seconds.
• To change the Chromotherapy setting, if not already there, press the Home/Menu button to access to the Main
Menu. Then use the navigation arrows to navigate to Settings, scroll right to access Chromotherapy modes. Once
desired setting is highlighted, press OK to preview. Press OK a second time to select. A green dot will appear to the
right of the selected mode.
NOTE: The default mode is Off.
To Next Page
Loading...