Need help?Do you have a question about the Dreizler marathon M 5001 and is the answer not in the manual?
Conditions required before initial burner setup.
Steps to take before the actual burner commissioning process.
The process of starting up and commissioning the burner.
Explanation of how the pneumatic linkage controls gas and air.
Adjusting the air damper for maximum load conditions.
Setting the manual damper for maximum load.
Procedure for setting the burner's load capacity.
Adjusting the air damper for minimum load conditions.
Procedure for setting the minimum burner load.
Explanation of how the gas and air ratio is controlled pneumatically.
How the pneumatic gas/air ratio control system automatically compensates parameters.
Steps to configure the gas/air ratio control system.
Setting gas and air dampers using the servomotor.
Adjusting the operating distance for the speed transmitter.
Configuration settings for the potentiometer.
Setting up the frequency converter and allocating frequencies.
Setting the required operating points for the load.
Setting the gas and air dampers for minimum load.
Setting the gas and air dampers for maximum load.
Fundamental settings for the gas and air damper.
Procedure for the initial startup of the burner.
Adjusting the burner for optimal performance.
Adjusting combustion air for small load conditions.
Optimizing the gas and air flow rates for correct mixture.
Final checks before handover and verification of thermostat function.
How the SQM 5 servomotor operates.
How the gas pressure switch MIN functions.
Steps to configure the gas pressure switch MIN.
Information on the installation type of the MIN pressure switch.
How the gas pressure switch MAX functions.
Steps to configure the gas pressure switch MAX.
Information on the installation type of the MAX pressure switch.
How the air pressure switch functions.
Steps to configure the air pressure switch.
Details on Marathon gas burners equipped with air pressure switches.
Overview of the quattro pro control unit's capabilities.
Information on operating the quattro pro control unit.
Steps to configure the controller using a pressure sensor.
Setting up the RWF 55 controller with a temperature sensor.
List of essential maintenance tasks for the burner system.
Torque values for screws and threaded plugs.
Guidelines for annual maintenance and replacement of safety components.
Guidelines on when to replace safety-relevant components.
To Next Page
General