The manufacturer is not responsible for radio
interference caused by unauthorized
modifications to this equipment. Such
modifications could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
$ This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
-4-
L.E.D.
LIGHT
CHARGER
BATTERY
PACK
2+<1/< 760-01
Charge Time 3 Hour
Voltage rating 120 V 60 Hz
+>>/<C:+-5 755-01 or 757-01
Voltage rating 4.8V or 7.2V
Capacity 200 mA
$23=-2+<1/<A366986C
-2+<1/ >2/ 09669A381
,+>>/<3/=755-01 & 757-01
!
WARNING
RELEASE TAB
1. Put the switch in the “OFF” position.
2. Squeeze release tabs on both sides of
battery pack, and remove pack from back of tool
as shown.
3. Align exterior shape of battery pack with
exterior shape of charger, squeeze release
tabs, insert battery pack into charger as shown
and release pressure on tabs so it locks in
place.
4. Plug charger into the power source. The
green L.E.D. light indicates connection has
been made and the battery pack is charging.
The L.E.D. light will blink while charging. The
L.E.D. will turn solid when charging is complete.
Under normal usage the tool normally requires
3 hours charging time to reach full capacity.
5. When charging is completed, squeeze
release tabs on battery pack and remove pack
from charger.
6. Align exterior shape of battery pack with
exterior shape of the hous ing of tool as shown.
Squeeze release tabs, insert battery pack into
back of tool, and release pressure on tabs so it
locks in place.
+?>398
?8->398+6/=-<3:>398+8.#:/-303-+>398=
2+<1381+>>/<C!+-5
SM 2610031419 02-13_SM 2610031419 02-13.qxp 2/28/13 2:41 PM Page 4
To Next Page
Loading...
