-11-
FIG. 9FIG. 8
Sand with a smooth
back and forth motion, allowing the
weight of the tool to do the work.
Avoid sanding with
only the tip of the pad. Keep as
much sand paper in touch with the
work surface as possible.
Always sand with the
pad and sandpaper flat against the
work surface. Work smoothly in a
back and forth motion.
Avoid tipping the
pad. Always sand flat.
Always cut with a
smooth back and forth motion.
Never force the blade. Apply light
pressure to guide the tool.
Do not twist the tool
while cutting.This can cause the
blade to bind.
Make sure flexible
scraper blade flexes enough
Avoid screw head
touching surface with flexible
scraper blade.
Please refer to figures 8 and 9 for further instruction on how to use your Dremel Multi-Max™.
Following these instructions will allow you to get the highest performance out of your oscilating tool.
To Next Page
Loading...
Need help?
General
