In case of a complaint, send the undismantled tool or charger
and proof of purchase to your dealer.
EXTENSION CORDS
!
WARNING
IF AN EXTENSION CORD IS
NECESSARY, A CORD WITH ADEQUATE
SIZE CONDUCTORS THAT IS CAPABLE OF CARRYING THE
CURRENT NECESSARY FOR YOUR TOOL MUST BE USED.
THIS WILL PREVENT EXCESSIVE VOLTAGE DROP, LOSS OF
POWER OR OVERHEATING. GROUNDED TOOLS MUST USE
3-WIRE EXTENSION CORDS THAT HAVE 3-PRONG PLUGS
AND RECEPTACLES.
NOTE: The smaller the gauge number, the higher the cord
capacity.
RECOMMENDED SIZES OF EXTENSION CORDS 240 VOLT
ALTERNATING CURRENT TOOLS
Max. Tool
Ampere Rating
Cord Ampere
Rating
Cord Sizes in
mm
2
Cord Lenght in
Meters
10 10 1.0 10
20 15 1.5 32
CONTACT DREMEL
For more information on the Dremel product range, support and
hotline, go to www.dremel.com.
NOISE AND VIBRATION
Noise / Vibration
Sound Pressure Level dB(A) <70
Sound Power Level dB(A) (uncertainty K = 3dB)
–
Vibration m/s
2
(triax vector sum) <2.5
Uncertainty K m/s
2
1.5
NOTE: The declared vibration total value has been measured
in accordance with a standard test method and may be used
for comparing one tool with another. It may also be used in a
preliminary assessment of exposure.
!
WARNING
THE VIBRATION EMISSION DURING
ACTUAL USE OF THE POWER TOOL
CAN DIFFER FROM THE DECLARED TOTAL VALUE
DEPENDING ON THE WAYS IN WHICH YOU USE THE TOOL.
MAKE AN ESTIMATION OF THE EXPOSURE IN THE ACTUAL
CONDITIONS OF USE AND IDENTIFY THE SAFETY
MEASURES FOR PERSONAL PROTECTION ACCORDINGLY
(TAKING ACCOUNT OF ALL PARTS OF THE OPERATING
CYCLE SUCH AS THE TIMES WHEN THE TOOL IS SWITCHED
OFF AND WHEN IT IS RUNNING IDLE IN ADDITION TO THE
TRIGGER TIME).
!
CN
11
To Next Page
Loading...
