avoid water marks.
* For discolorations or deposits that persist, use a non-scratching household cleanser
or stainless-steel polishing powder with a little water and a soft cloth.
* For stubborn cases use a plastic scouring pad or soft bristle brush together with
cleanser and water. Rub lightly in the direction of polishing lines or “ grain” of the
stainless finish. Avoid using too much pressure that may mar the surface.
* Do not
allow deposits to remain for long periods of time.
* Do not use ordinary steel wool or steel brushes. Small bits of steel may adhere to the
surface causing rust.
* Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds to
remain in contact with stainless steel for extended periods. Many of these compounds
contain chemicals that may be harmful. Rinse with water after exposure and wipe dry
with a clean cloth.
*
Painted surfaces should be cleaned with warm water and mild detergent only.
TROUBLE SHOOTING
The rangehood may not work or work improperly. Before calling after-sales service,
switch off the appliance, unplug the power supply and refer to this guide to determine
the problem.
If malfunction persist, contact our After Sales Service and specify the nature of the
problem, appliance model no and serial number (on the rating plate inside the hood)
Status Reasons Solutions
No response
of the lamps
and the
motor
3. The plug is off from
the power socket.
4. The power cord is
3. Ensure that the plug is put into
the power socket properly.
4. Replace the power cord if the
The fuse on the PCB
Replace the fuse on the PCB board.
The switch is damaged. Repair or replace the switch.
26
To Next Page
Loading...