Dritz 16P - Applying 7;16 Pearl Snap Stud; Removing 7;16 Pearl Snaps

16P SNAP PLIERS – 7/16" Pearl Snap Instructions (cont.)
Applying Stud (Underside of garment):
1. Insert yellow prong holder in
other side of pliers. (Orange
stud/socket holder remains in
opposite side of pliers.)
Removing Tools:
Slip hook of gray tool remover
inside ledge of pliers and press
down to release tool.
Repeat for opposite side.
Right side of
fabric underside
Wrong side
of fabric
Wrong side
of fabric
1. 2. 3.
4.
2. Position prong, point side out, in
yellow prong holder. Position stud,
ball side down, in orange
stud/socket holder.
3. Position underside of garment in
pliers with prong on the wrong
side of garment. Center over
marked position.
4. Squeeze pliers rmly to apply snap.
Check for tightness; squeeze again,
if necessary.