CAUTION:
Please use extreme care when installing on
fiberglass tubs. DO NOT OVERTIGHTEN as
the clamp may crack the fiberglass.
1. Clean Bathtub thoroughly and wipe dry
before applying rail. Contact surfaces
must be dry and free of soapy residue to
assure secure installation.
2. Deploy knob (A) and open until rail is
wide enough to slip on side of bathtub.
3. Place Safety Rail on bathtub with knob
(A) facing outside of tub and tighten until
rail feels tight and secure.
4. To test installation of rail, pull forward,
back and side to side. If rail slips or
moves, make sure surface is free of soapy
film and is dry, then replace at desired
location and retighten.
Safety rail oen requires retightening from
time to time. Check periodically before use
and retighten as needed.
installation
instructions
Item # 12039
Item # 12044
A
A
Rev.3.04.15.14
To Next Page
Loading...
