Key Operation Description
Digital Operator
Display
1
PRGM
(Fn)
*Enter program mode
*Display the current function
code
)Q
2 or keys
*Press up or down keys to select
the desired function code.
)Q
3
READ
ENTER
*Display the current function
parameter.
*DATA lamp light
4 or keys
*Press up or down keys to
change the displayed function
parameter data.
5
READ
ENTER
*Press READ/ENTER to save
the displayed function parameter
into memory.
*DATA lamp goes out
*Digital operator displays the
current frequency.
(QG
;;;;
6 Repeat steps 1-5
*Changing another function
parameter.
7 STOP
*Function parameter setting
procedure ends.
*Enter stopping mode.
*Digital operator displays the
current frequency.
;;;;
35
5.2 Function Parameter Setting (effective in program mode)
5.2.1 Changing the Function Parameters
0.5 sec.
Hz
DATA
DATA
Hz
∧ ∨
∧ ∨
indicates blinking display.
Note: XXXX displays the current frequency set at Fn24 (jog), Fn25 (normal), Fn11=0, and Fn11=1
(analog input terminal 12-14), or setting of speed at Fn17 (Fn11=2, 3, 4) Displayed value depends on
which frequency mode is in use. The display of the digital operator will blink with the current
frequency setting.
Table 5.2a Changing Function Parameters
To Next Page
Loading...