Drop X - USE, CARE AND SERVICING OF THE POOL; Using the pool

ADroppoolcanbelledwithapprox.1,500litersofwater.Pleasenotethatthe
waterlevelrisesasthenumberofbathersincreases.Thepoolislledwithcleanwater
by using a garden hose, for example.
Never turn on the equipment or keep it running when the pool is empty of water.
Only turn on the equipment when:
1. the required amount of water has been reached (water
level approx. 10 cm below the pool’s edge)
 2. thelterhandleisintheFILTERposition
3. the pool is in READY mode (control panel in the equipment
compartment).
Keep the pool’s insulation cover closed during heating and always when the pool
is not in use. Make sure that the pool always has enough water and that all jets are
below the water surface.
Using the pool
You can set the desired temperature using CMS™ remote control (Drop X, Vuolle
or option) or the control panel. These controls can also be used to adjust the timer
and otherwise control the equipment.
There are two switches on top of the pool that can be used while bathing.
1. Aeration/massage system (Drop X, Vuolle, S and Lähde) —press
  thebuttontoturnthemassaging bubbleson/o.Thebubbles
run for 15 minutes.
2. Light switch—by pressing the button, you can change the color
of the pool’s LED lights to the color of your choice. The same
  buttonturnsthelightson/o.
USE, CARE AND
SERVICING OF THE POOL
1 2