Drop X - Jet pump (Drop X, S, Vuolle & Lähde); Setting the temperature

Jet pump (Drop X, S, Vuolle & Lähde)
The pool’s pump is turned on by pressing the JETS 1button(4).Thepumpstarts
eitheratltrationormassagingspeed,dependingonthepoolmode.Ifthepump
startsatltrationspeed,youcanturnonmassagingspeedbypressingthe JETS 1
button (4) again. The massaging speed turns o automatically after 15 minutes
andtheltrationspeedafter30minutes,oryoucanturnthemobypressingthe
JETS 1button(4).Ifthepoolisin READYmode,theltrationspeedturnson
automatically when the pool checks the water temperature every 30 minutes. If the
ltrationspeedhasturnedonautomatically,itcannotbeturnedo,butyoucan
turn on massaging speed by pressing the JETS 1 button(4).
Setting the temperature
The pool temperature is factory set to 37 °C. The temperature setting is adjusted with
the WA R M and COOL buttons (1)(2). When the desired temperature is no longer
blinking on the display, the pool starts heating the water to the set temperature if
necessary. PLEASE NOTE! The actual water temperature will not be shown until
the pump has run for at least two minutes.
Setting the time
The time must be set immediately after the pool’s installation, as the correct time is
importantforthefunctionalityoftheltrationcycles.Tosetthetime,rstpressthe
MENU button (3) repeatedly until you see TIME on the display. After pressing the
WA R M button, you can set the time with the WAR M and COOL buttons (1)(2).
Move on to the next phase by pressing the MENU button (3). PLEASE NOTE! If
thepoollosespowerorthepoweristurnedo,thetimemustbereset.
Turning the display
Toturnthedisplay,rstpresstheMENU button (3) repeatedly until you see FLIP
on the display. After this, you can turn the display with the WA R M and COOL
buttons (1)(2).
LED lights
The pool’s LED lights can be turned on by pressing the LIGHT button (5). To
turnothelights,presstheLIGHT button (5) again. The pool’s LED lights have
dierentcolorsandlightmodes.Tochangethelightmode,turnotheLEDlights
andimmediatelyturnthembackon.TheLEDlightsturnoautomaticallyfour
hours after being turned on.