To Next Page

To Previous Page

Keylock

Tolockthepool’scontrolpanel,rstpresstheMENU button (3) repeatedly until

you see LOCK on the display. After this, lock either the water temperature settings

(TEMP) by pressing the WAR M button (1) or the whole control panel (PANL) by

pressing the MENU button (3) again. Change the setting (ON/OFF) by pressing

the WAR M or COOL button (1)(2). Save your choice and exit the menu by pressing

the MENU button (3).

To open the keylock, press the WA R M button (1) while simultaneously calmly

pressing the MENU button (3) twice.

Modes

In order to keep the pool water warm, the pump circulates the water through heaters.

In the READY mode, the pool maintains the set temperature and heats up the

water as necessary. In the REST mode, the pool heats up the water only during set

ltrationcycles.IntheREST mode, the pool display may not necessarily show the

pooltemperaturebutthetext RUN | PUMP | FOR | TEMP | -- --

-- -- instead.Tochangethemode,rstpresstheMENU button (3) repeatedly until

you see MODE on the display. Choose the desired mode by pressing the WA R M

button (1) or the COOL button (2). Exit the menu by pressing the MENU button

(3).PLEASENOTE!Thechosenmodeisshownatthebottomofthedisplay.

Service mode

The service mode (HOLD) can be used to stop the pump when carrying out small-

scale servicing work, for example. The service mode lasts for 60 minutes. To start

theservicemode,rstpresstheMENU button (3) repeatedly until you see HOLD

on the display. After this, press the WAR M button (1). The display now reads

HOLD | ING | FOR | 0:60 (the running timer shows the remaining

time for which the pumps will be disabled).

Lower and upper temperature ranges

Thepoolhastwodierentsettingsfortemperatureranges.Youcansetaseparate

temperature for each of them. The selected temperature range is shown at the

bottom of the display.

In the upper temperature setting (RANGE), the temperature can be set between

27°Cand40°C.Thissettingisbestsuitedforusewhenyouwanttokeepthepool

always ready for use. In the lower temperature setting (RANGE), the temperature

can be set between 10 °C and 27 °C.

Drop X User Manual

Questions and Answers: