To Next Page

To Previous Page

The lower temperature range is best suited for use when the pool is not used for an

extended period of time and you do not want to maintain a high temperature. To

changethetemperaturesetting,rstpresstheMENU button (3) repeatedly until

you see TEMP on the display. Choose the desired mode by pressing the WAR M

button (1). Save the setting and exit the menu by pressing the MENU button (3).

PLEASE NOTE! The selected setting is shown at the bottom of the display.

Filtration cycles

Filtration cycle 1 is factory set to run from 8:00 pm to 10:00 pm. To change the

ltrationcycle’sstarttimeandduration,rstpresstheMENU button (3) repeatedly

until you see FLTR1 on the display. After this, press the WAR M button (1) twice

andthenchangethestarttimeoftheltrationcyclewiththeWA R M and COOL

buttons (1)(2). Move on to the next phase by pressing the MENU button (3). After

settingthestarttime,setthedurationoftheltrationcycleinthesameway.

Filtration cycle 2 is factory set to run from 8:00 am to 10:00 am. To change the

ltrationcycle’s start time and duration, press theMENU button (3) repeatedly

until you see FLTR2 onthedisplay.Youcanchangethesecondltrationcycle’sstart

timeanddurationinthesamewayastherstltrationcycle.

Innormaluse,werecommendsettingtwo2-hourltrationcyclesperday.Inthis

case,theintervalbetweenthestarttimesoftheltrationcyclesmustbe12hours.

Forexample,theltrationcyclescanbethesefactorysetperiods8:00–10:00pmand

8:00–10:00 am. PLEASE NOTE! If you use the pool more frequently than three

timesperweek,thelengthoftheltrationcyclesmustbeincreased.

Cleaning cycle

The pool has an automatic preset cleaning cycle. The cleaning cycle starts when the

pumphasbeenturnedoforatleast30minutes.

Drop X User Manual

Questions and Answers: