Druck DPI 705 User Manual

K215 Issue No. 2
Druck Limited, Fir Tree Lane, Groby, Leicester, LE6 0FH, England
Tel: +44 (0) 116 231 7100 Fax: +44 (0) 116 231 7103
Email: sales@druck.com Internet http://www.druck.com
Druck DPI 705 and DPI 705 IS
Digital Pressure Indicators
Preparation
1.
Connect the instrument
to a pressure source
that has an accuracy
three times better than
the instrument.
Recommended:-
Druck DPI 610 or DPI
610 IS Portable
Calibrator.
2.
Switch on the instrument
and select the units of
pressure measurement
required for calibration.
Procedure
1.
Press all three keys
together to enter the
CAL menu and proceed
as shown:
Changing the PIN
Each digit can be
changed in turn.
Pressing:
increases the
value of the digit.
steps to next digit,
left
to right.
enters the PIN
Calibration Instructions
WARNING: CALIBRATE DPI 705 IS INSTRUMENTS IN A SAFE AREA.
a
d
The instrument performs a two-point compensation at ZErO and FS (full-scale.)

Druck DPI 705 Specifications

General

Brand	Druck
Model	DPI 705
Category	Measuring Instruments
Language	English

Summary

Calibration Instructions

Preparation

Connect instrument to pressure source and select measurement units for calibration.

Calibration Procedure

Step-by-step guide for zero and full-scale calibration, including PIN entry and confirmation.

PIN Management

Instructions on how to change the instrument's Personal Identification Number (PIN).

Configuration Instructions

Software Version Display

Shows the current software version installed on the instrument.

Unit and Setting Configuration

Configure measurement units and On/Off settings for the instrument.

LOCK Mode Operation

Details the functionality and limitations of the LOCK mode for instrument operation.