Need help?Do you have a question about the Druck UPS-III-IS and is the answer not in the manual?
General| Intrinsic Safety | ATEX, IECEx certified |
|---|---|
| Pressure Media | Non-corrosive gases |
| Operating Temperature | -10°C to 50°C |
| Output Signal | 4 to 20 mA |
| Power Supply | 9 V dc |
| Material | Stainless steel |
| Process Connection | 1/4 NPT female |
Details product, manufacturer name, and address.
Lists relevant EU legislation and harmonised standards.
Information on notified body, signature, and date of issue.
Specific requirements for installing in hazardous environments.
Explains the certification marks on the device.
Covers batteries, safety conditions, and casing.
Lists accuracies for different measurement and sourcing modes.
Specifies approved battery types for the instrument.
Details dimensions, weight, terminals, case, and environmental ratings.
Lists electrical parameters for various input/output modes.
Explains the function of each button on the calibrator.
Describes how to switch between measure and source modes.
Details how to perform measurements using the device.
Step-by-step guide for measuring loop current.
Steps for measuring current while supplying 24V.
Step-by-step guide for measuring voltage.
Instructions for conducting continuity tests.
Steps for sourcing a specific mA output.
Steps for sourcing mA while providing 24V loop power.
Details functions like Step, Auto-step, Span Check, and Ramp.
How to use the calibrator with a HART communicator.
Information on repairs, calibration checks, and cleaning.
Instructions for safely replacing the instrument's batteries.
Recommendations on calibration period and technician qualifications.
Specifies accuracy needs for calibration test equipment.
Accuracy data for mA and V measurement modes.
Accuracy data for mA sourcing mode.
Steps to verify instrument calibration against standards.
Guide for performing calibration adjustments and setting the date.
To Next Page
