EasyManua.ls Logo

DS Automobiles DS 7

DS Automobiles DS 7
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
136
Driving
06
flashing, after a delay of about one second,
when overtaking a vehicle slowly, and when the
direction indicator is used.
Activation/Deactivation
It is configured in the ADAS touch screen
application.
When starting the vehicle, thewarninglamp
comes on in each mirror to indicate that the
system is activated.
The status of the system is memorised when the
ignition is switched off.
The system is automatically deactivated
when towing with a towing device
approved by the Manufacturer.
Operating conditions
All vehicles are moving in the same direction
and in adjacent lanes.
The speed of your vehicle must be between 7
and 87 mph (12 and 140km/h).
When overtaking a vehicle, the speed
difference is less than 6mph (10km/h).
When overtaken by a vehicle, the speed
difference is less than 16mph (25km/h).
Traffic is flowing normally.
Overtaking a vehicle over a certain period of
time and the vehicle being overtaken remains in
the blind spot.
You are driving on a straight or slightly curved
road.
Your vehicle is not pulling a trailer, a caravan, etc.
Operating limits
No alert is triggered in the following conditions:
presence of stationary objects (e.g.parked
vehicles, safety rails, lampposts, signs).
vehicles travelling in the opposite direction.
on winding roads or in case of sharp turns.
when overtaking or being overtaken by a
very long vehicle (e.g.truck, bus), which is both
detected in a blind spot from behind and present
in the driver's field of vision from the front.
quick overtaking manoeuvre.
very heavy traffic: vehicles detected in
front and behind are confused with a lorry or a
stationary object.
Malfunction
If the event of a malfunction, this warning
lamp lights up on the instrument panel,
accompanied by the display of a message.
Have it checked by a dealer or a qualified
workshop.
The system may be temporarily disturbed
by certain weather conditions (e.g.rain,
hail).
In particular, driving on a wet road or going
from a dry to a wet area can cause false alerts
(e.g.presence of a cloud of water droplets in
the blind spot interpreted as a vehicle).
In bad or wintry weather, ensure that the
sensors are not covered by mud, ice or snow.
Take care not to cover the warning zone in the
door mirrors, or the detection zones on the
front and rear bumpers with adhesive labels

Table of Contents

Related product manuals