68
Lighting and visibility
04
need for vigilance on the part of the driver who
must continually adapt the driving of the
vehicle to the visibility and traffic conditions.
Activation/Deactivation
► Place the ringof thelighting control stalk in
the “AUTO” position.
It is configured in the Settings> Vehicle
touch screen application.
Operation
"City" mode
The width of the beam is increased to better
distinguish hazards on the side of the road
(pedestrians, intersections).
By default, the function starts in "Road" mode.
After a few seconds, the function switches to
"City" mode as long as the speed is below 19 mph
(30km/h).
This mode is deactivated after a few seconds
above 31 mph (50km/h).
"Road" mode
This lighting provides a higher light beam, an
increased intensity of the headlamps and a
decreased intensity of the modules.
This mode is active as long as the rear foglamps
are switched off and/or the front wipers are
activated for less than 2minutes.
Between 19 mph (30km/h) and 43 mph
(70km/h), with the rear foglamps off and if the
front wipers activated for more than 2minutes
continuously, the function switches to "Rain"
mode.
"Rain" mode
The beam is widened. The power of the modules
is increased to enable the driver to see the road
markings more easily, whilst the intensity of the
main headlamps is reduced so as to improve the
driver’s vision (taking reflections caused by a wet
road into account).
Between 19 mph (30km/h) and 43 mph
(70km/h), with the rear foglamps off, front
wipers activated for many minutes continuously,
the function switches to "Road" mode.
"Fog" mode
This mode is activated if the vehicle is moving at
a speed between 0 and 43 mph (70km/h) and the
rear foglamps are on.
Beyond 43 mph (70km/h), the function switches
to "High beam" mode even if the rear foglamps
are activated.
To Next Page
Loading...
Need help?
General
