91
Safety
05
An incorrectly installed child seat in a
vehicle compromises the child's safety in
the event of an accident.
Strictly observe the fitting instructions
provided in the user guide supplied with the
child seat.
For information about the options for
fitting ISOFIX child seats in your vehicle,
refer to the summary table.
Recommended ISOFIX child seats
Also consult the user guide from the child
seat’s manufacturer to find out how to
install and remove the seat.
"RÖMER Baby-Safe and its ISOFIX base"
(size category: E)
Group 0+: from birth to 13 kg
Installed "rearward facing" using an ISOFIX
base which is attached to ringsA.
Only suitable for installation on the front
passenger seat or the outer rear seats.
The base has a support leg, height-adjustable,
which rests on the vehicle's floor.
This child seat can also be secured with a seat
belt. In this case, only the shell is used and
attached to the vehicle seat using the three-
point seat belt.
"RÖMER Duo Plus ISOFIX"
(size category: B1)
Group 1: from 9 to 18 kg
Suitable for forward-facing installation only.
Attached to ringsA and ringB, referred to as
TOP TETHER, using an upper strap.
Only suitable for installationon the front
passenger seat or the outer rear seats. The
head restraint on the vehicle seat must be
removed.
Three seat body angles: sitting, reclining, lying
down.
This child seat can also be used in seat
positions not equipped with ISOFIX mountings.
In this case, it must be secured to the vehicle's
seat by the three-point seat belt. Adjust the
front seat of the vehicle so that the child's feet
do not touch the backrest.
To Next Page
Loading...
Need help?
General
