1210 11 13 14
15
#
WELIKEITLOUD
1. HIGH INPUT - High level input terminal.
Pass-Throughputs: When input audio signal from HIGH INPUT port can start
amplifier working directly instead of using REM cable from POWER.
2. LOW INPUT - Left and right channels inputs of the amplifier system. Preamplifier
outputs of a source (head unit, CD player, DAT, etc.) or of an external electronic
crossover must be connected to them.
3. GAIN - Knob for volume adjustment.
4. BASS BOOST-The Boost range from 0dB to 18dB.
5. BASS FREQUENCY-The boost frequency range from 40Hz to 100Hz.
6. LPF - Low pass frequency adjusting knob, the frequency range from
50Hz to 150Hz.
7. PHASE CONTROL - Phase adjusting switch, the phase ranges from 0°~180°.
8. REMOTE CONTROLLER OUTLET - To be connected with the remote
controller, which helps to boost the gain. Please turn the knob of volume to be
maximum before using the remote.
9. REMOTE CONTROLLER - Volume Level Knob, the Gain range from 0.2V
to +6V.
10. INDICATOR LIGHTS - When power LED send out blue light, it means that this
amplifier have being working now.
When protection LED send out red light, it means that the self-protection of the
amplifier.
11. GND - Ground terminal. Connect to the car chassis. Keep the length of the
ground cable to a minimum.
12. REM - Terminal to be connected with Remote cable, which come from the
source and which control the amplifier switching on. Applied voltage must be
between 10 and 15V DC.
13. +12V - Anode of power connection terminals. Connect to the anode of
car battery.
14. FUSE - Standard automatic fuse, you must use the same power fuse if
you need to change it.
15. SPEAKER - Speaker connecting terminal.
specifications
electrical connection
instructions for functions and controls
To Next Page
Need help?
General
