How to fix a DS18 GEN-X G1800.1D Amplifier with no sound?
If your DS18 Amplifier produces no sound, try the following: * Check all the amplifier's fuses. * Ensure the turn-on lead is properly connected. * Inspect the signal leads. * Check the gain control. * Verify the Tuner/Deck volume level. * Clean the contacts in the fuse holders.
Why is my DS18 Amplifier not turning on?
If your DS18 Amplifier isn't turning on, there could be a few reasons: * There might be no power reaching the power wire. In this case, repair the power wire or its connections. * There might be no power to the remote wire when the receiver is on. Check the connections to the radio. * The fuse might be burnt or broken. Replace the fuse.
General| Model | G1800.1D |
|---|---|
| Channels | 1 |
| Amplifier Class | D |
| RMS Power at 1 Ohm | 1800W |
| RMS Power at 2 Ohms | 1200W |
| Power Output (RMS) | 1800W |
| Input Sensitivity | 0.2V - 6V |
| Efficiency at 4 Ohm | 85% |
| Crossover Range | 50Hz - 250Hz |
| Bass Boost Frequency | 45Hz |
| Subsonic Filter | 10Hz - 50Hz |
| Remote Level Control | Yes |
| Low Pass Filter | 50Hz - 250Hz |
| Operating Voltage | 9V - 16V |
| Signal to Noise Ratio | >90dB |
| Damping Factor | 150 |
| Bass Boost | 0 to 12 dB |
| THD | <0.1% |
| Fuse Rating | 80A |
To Next Page
