Need help?Do you have a question about the DS18 JP6 and is the answer not in the manual?
General| Brand | DS18 |
|---|---|
| Model | JP6 |
| Category | Car Stereo System |
| Language | English |
Details about the speaker's motor components, including coil, former, winding, and magnet material.
Technical parameters for speaker enclosure design and performance, like Vas, Xmax, Fs, and Qts.
Unclip and remove the panel below the steering column, removing two Phillips screws.
Unclip, unplug, and remove the climate control panel.
Remove two Phillips screws securing the radio trim panel, then unclip and remove.
Remove eight Phillips screws for instrument and airbag panels, then unclip steering column shroud.
Open driver's door, unclip and remove dash side panel, removing five Phillips screws.
Remove five Phillips screws securing the speaker panel, then unclip and remove.
Loosen dashboard brace, then remove speaker pod and its electronic module.
Remove passenger dash side panel and grab-bar trim panel, with associated screws.
Remove airbag trim panel and glovebox, including all securing screws.
Remove passenger airbag screws and then the speaker pod from the dashboard.
Install new DS18 pods, connecting the supplied speaker connector to the factory speaker harness.
Reassemble the dash in reverse order, ensuring the electronic module is reconnected.
To Next Page
