DSC IMPASSA Quick Start Installation Guide

panels, keypads & modules
Contact your DSC distributor.
www.dsc.com | 1-888-888-7838
IMPASSA
Self-Contained 2-Way Wireless Security System
Quick-Start Installation Guide
1. Remove the Front Plate
Using a small screwdriver, insert in the bottom left and right-hand slots and
gently pry to separate the front panel.
2. Mount the Back Cover
Begin by routing telephone line wiring, Input/Output wiring and AC power
wiring through the cutout in the back cover. Determine placement location
and mount the back cover to the wall using the screws and drywall plugs.
Note: For versions supporting cellular communications, the cellular signal
strength can be first checked in section [850], to determine the optimal
location to mount the unit.
3. Connect Wiring
Connect wiring to the terminal block on the back cover.
4. Connect the Battery
Connect the battery cable to the connector on the PCB, ensuring proper
orientation of the connector.
5. Attach the Front Cover
Place the top portion into the back cover first and press the bottom portion
into the back cover to snap into place.

DSC IMPASSA Specifications

General

Model	DSC IMPASSA
Event Buffer	500 events
Two-Way Voice	Yes
Type	Security System
Keypads	4
Communication	GSM, GPRS, IP
Power Supply	16.5VAC, 40VA
Battery Backup	24-hour backup battery
Compatible with	DSC wireless devices
Backup Battery	24-hour backup battery