4
NOTE: If Quick Arm is not enabled by the installer, then a numerical keypad is displayed (see
Figure 4). Enter a valid access code to proceed.
Figure 4 - Keypad
If Disarm is selected during the exit delay, a numeric keypad is displayed.
• Enter (tap) your access code.
• The arming sequence is aborted and the system returns to the Home screen.
• The Armed LED turns OFF.
At the end of the pre-programmed exit delay:
• The Disarm screen is displayed.
• The Ready Indicator turns OFF.
• “Stay Armed-Bypass” is displayed in the Status Bar.
NOTE: This screen will go into stand-by mode after 15 minutes. Tap the screen to restore the dis-
play.
To Next Page
Loading...
