To Next Page
D
danielle51Aug 8, 2025
What to do if my DSPM Eternalight 3 alarm keeps beeping?
- KKatherine HughesAug 8, 2025
If the alarm keeps beeping, it might be because the unit is overloaded. Try reducing some of the load.
What to do if my DSPM Eternalight 3 alarm keeps beeping?
If the alarm keeps beeping, it might be because the unit is overloaded. Try reducing some of the load.
How to troubleshoot a DSPM Eternalight 3 that doesn’t operate?
If your DSPM Inverter doesn’t operate, with no lights or warning sounds, here are a few things to check: * First, ensure that the input power source is available and the main input circuit breaker is on. * Next, verify that the Emergency Lighting Inverter System input circuit breaker is also on. * Make sure you are pressing the “ON” button for at least 1 second. * Finally, turn off the Inverter and remove all load to check for output short circuits or overloads.
What to do if the battery light is on when powered by utility in my DSPM Eternalight 3?
If the battery light is illuminated while the DSPM Emergency Lighting Inverter System is powered by utility, it could indicate that the batteries have low voltage or are not properly connected. Ensure the batteries are correctly connected. If you notice any damage to the batteries, contact DSPM immediately.
Why is the utility light blinking on my DSPM Eternalight 3 Inverter?
If the utility indicating light is blinking on your DSPM Emergency Lighting Inverter, the utility voltage might be exceeding the Emergency Lighting Inverter input range. Verify the input voltage.
What to do if the available battery time is too short on my DSPM Eternalight 3?
If the available battery time is too short, the batteries may not have been fully charged. Keep the Emergency Lighting Inverter System turned “ON” for more than 20 hours to recharge the batteries.
General safety precautions for operating electrical equipment.
Explanation of safety symbols and general safety advice.
Overview of the Emergency Lighting Inverter System and its purpose.
Explanation of how the system operates in different modes.
Details on the power output ratings of the inverter.
Specifies the available input voltage and frequency.
Details the output voltage and efficiency.
Information on battery types and warranty.
Details on overload, surge, and undercurrent protection.
Self-diagnostic capabilities and maintenance features.
Details on warranty coverage for electronics and batteries.
Steps to inspect the unit upon receipt.
Guidelines for choosing a suitable installation site.
Step-by-step guide for powering up the system.
Step-by-step guide for powering down the system.
General| Output Frequency | 50Hz |
|---|---|
| Efficiency | 90% |
| Protection | Overload, Short Circuit |
| Cooling | Fan Cooling |
| USB Port | 5V/2.1A |
