DT Research DT301C User Manual

DT301C/ DT301S
OPERATION
Powering ON and OFF
To acvate the DT301C/ DT301S, push and quickly release the Power Buon. The display
will come on in a few seconds. To put the DT301C/ DT301S in Standby mode, push and
quickly release the Power Buon. To turn the DT301C/ DT301S off for extended storage,
power off safely using any soware funcon that
“
shuts down computer
”
provided in the
soware operang system.
NOTE:
The
baery pack shipped with your tablet may be low in power. Please use the
AC-DC adapter with the DT301C/ DT301S when seng up for the first me to
fully charge the baery pack, or use the oponal baery charger kit.
NOTE:
When the baery pack is charging, the blue-colored Baery LED should blink
slowly. If plugging in the AC-DC adapter does not trigger this blinking acvity and
the LED stays dark, t
he baery pack may have been drained substanally. Try
unplugging/ replugging the AC-DC adapter to the DT301C/ DT301S a few mes to
acvate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Buon to put the
tablet in
“
Standby
”
mode while not in use. Pushing briefly on the same buon
will wake up the system within seconds.
NOTE:
Avoid using the Power Buon (
“
hold
4+ seconds
”
feature) to turn off the
tablet
—
this form of hardware shutdown is intended to be a means of recovery
from lockups, and not as normal operaon.
ENGLISH
4
5
ENGLISH
Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate interface
will be displayed aer a launch sequence of several seconds. The wireless LAN connecon
may take 10-15 seconds to be established.
Configuring the Mobile Tablet
The DT301C/ DT301S may be configured using the ulies and methods dictated by
the soware operang system. The DT301C/ DT301S should be configurable for various
properes such as user profiles, network features, and several system elements.
Wireless Networking
Wireless LAN
The DT301C/ DT301S is oen delivered with an embedded (user-inaccessible) 802.11ac
WLAN adapter equipped with a hidde
n custom antenna.
T
• hrough the support of typical WLAN adapters, the DT301C/ DT301S will detect
802.11 access points in the vicinity for you to select the access point of your choice
for connecon.
T
• he SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT301C/ DT301S and
the access points have to match. The SSID is case-sensive and it is recommended
that you enable WEP/WPA/WPA2 encrypon (or
advanced alternaves) for secure
access.
W
• hen WEP/WPA/WPA2 is enabled, you may need to consult your network admin-
istrator or your networking equipment literature to properly configure associated
sengs such as Authencaon mode, etc.
R
• efer to the access point operang manuals for seng up the 802.11 access points.

DT Research DT301C Specifications

General

Brand	DT Research
Model	DT301C
Category	Tablet
Language	English