5
www.dtar.com |
To reconfigure the Wave-Length Multi-Source for
stereo output, follow these steps:
1. Look inside the guitar and find the cable clamps
that secure the pickup lead wire, battery wires and Control
Module cables going to the preamp chassis. Loosen only
the cable clamps necessary to allow the preamp chassis
to be moved as far as the sound hole. Do not attempt to
remove the adhesive backed clamps from the guitar; you
only need to un-bend them slightly so the cable cables
can be moved.
2. Remove the strap button and outer nut and washer from
the endpin jack. Keep this hardware in a safe place so you
will not lose it.
3. Carefully slide the endpin/chassis assembly free from the
end block of the guitar and move it into view from the
sound hole. Do not apply any stress to the any of the cable
attached to the preamp, especially the pickup cable.
4. Remove the two small screws that secure the chassis top
to the sides. Put the top and screws with the other
hardware.
5. Refer to figure 1 (on page 6). If you have the original style
product, it will be necessary to cut or remove the small
wire jumper indicated and resolder a jumper from the center
connection point to the left connection point. If you have the
Converting the output signal to stereo operation
To Next Page
Loading...