Overview
This quick start guide provides instructions and diagrams describing how to quickly connect and
configure the SOL8SDR2x2W-P device to join a Mesh network.
Note: If configuring as a SOL-TX or SOL-RX, please refer to the relevant user guides.
Supporting software applications and detailed user guides can be downloaded from DTC’s WatchDox
facility. Please contact the DTC support team:
Phone US: +1 571 563 7077
Phone UK: +44 1489 884 550
Email US: us.technical.support@domotactical.com (no restricted content)
Email ROW: uk.technical.support@domotactical.com (no restricted content)
Connections
The minimum connections required for an SDR2x2W-P to join a Mesh network are power and
antennas. An Ethernet connection to a PC is required for initial configuration.
Note: CA3172 PSU or CA0002 connected to an 8-18VDC power source can be used as power
options.
Depending on how the SDR2x2W-P is to be deployed, a video source, audio headset, or serial data
connections may be attached for additional functionality. Please refer to the user guides for details.
Note: The cables in the image below are provided for illustration, a full list of cable options can be
found in the datasheet or user guide.
To Next Page
Need help?
General