2 Setup
Intended use
The DT-300 is intended to create new sounds for your synthesizer.
The DT-300 is a programmer for the Alpha Juno 1, 2 and MKS-50
synthesizers.
What is included
Please ensure that your DT-800 includes the following:
• DT-300 Programmer
• Worldwide power supply
• 5pin Male-Male MIDI Cable
3 Installation
Connecting the DT300 with the Juno:
1. Connect Midi out from DT300 to midi in on the Juno.
2. Push MIDI button on Juno until MIDI CH = .. is shown.
3. Turn alpha dial until MIDI CH = 1 is shown.
(or set DT300 to the same midi channel as the alpha juno)
4. Push the MIDI button until MIDI EXCL is shown.
5. turn alpha dial until MIDI EXCL = ON is shown.
Write MIDI data to memory:
Set memory protect switch on back of the juno to OFF
push MIDI button
While holding down WRITE button, push the MIDI button
(display shows: Write Complete!)
To Next Page
Loading...