4 Operation
Power
• When setting up the DT-300 with the JUNO, turn both of them
off.
• This unit might not work properly if turned on immediately after
turned off. If this happens, simply turn it off and turn it on again
a few seconds later.
• Be sure to use the supplied AC Adaptor. Using any other
adaptor may cause trouble.
Starting up
Switch on the JUNO, then the DT-300.
The LED in the MANUAL button will lite up, the number of flashes
show you the current midi channel
(1 flash is channel 1, 2 = 3 etc..)
Depending on the stored setting, the LEDS of the faders will be on or
off.
To control the JUNO with a MIDI device, connect the MIDI OUT of the
MIDI device to the MIDI IN Connector on the Programmer. The DT-
300's MIDI messages for tone color editing and the messages fed
into the MIDI IN are mixed and sent through the MIDI PROGRAMMER
OUT.
Tone Edit
This Tone Edit function is useful for slightly modifying the tone color.
Select the tone color to be modified on the JUNO.
Using the knobs on the Programmer, edit the tone color.
If you move a desired knob even slightly, its setting position of that
tone color will be deleted and ready to be manually controlled.
To Next Page
Loading...