E N G L I S H
NOTE:
This instruction manual contains inportant information about the istallation and of F1
Plese read and follow these instruction carefully.
INSTRUCTIONS:
-1. Use only alternating current connection. Check if the voltage rating on the plate corresponds
to the voltage.
-2. Disconnect immediately the unit if the body or power supply cable are damaged in any way.
-3. Use only smoke fluid recommended by D.T.S. (Don’t water liquid down).
-4. Don’t touch the hot surfaces and power supply cable during running.
-5. Only a specialist can repair the smoke machine ( turn to your supplier)
-6. Use only spare parts from D.T.S.
-7. D.T.S. Doesn’t take any responsability for any damage due to an incorrect and inappropriate
use.
FOR SAFETY:
-1. Before any maintenance (filling up the smoke fluid tank)turn off the machine and disconnect
the unit.
-2. Don’t pull the cable and plug to disconnect the unit.
-3. Don’t touch hot surfaces. Never immerse cable plug or the body of the machine into the
water or any liquid to avoid incidents shock or fire.
TECNICAL SPECIFICATIONS:
F1 has been manufactured by first rate quality components. It’s equipped with a termal fuse
(as over-heat protection) for the safety of the user.
It’s possible to put the machine into service by a low tension remote control.
The remote control is equipped with a led representing unit is ready.
When the F1 reaches temperature running, it is able to deliver non-stop smoke for 14 seconds.
After which the led needs 1 minute tobecome red.
PUTTING INTO SERVICE
CONNECT THE PLUG.
-Turn on the smoke machine by the switch.
-Connect the remote control into the jack plug.
-The machine needs a warm up time. You can see the unit is ready thanks to the red led, located
on the remote control.
MAINTENANCE:
It’s essential that the heating is kept clean. We recommend the proper liquid, you can find on
the market.
F 1
F o g m a c h i n e
4
To Next Page
Loading...
Need help?
General