from step 1 to re establish the appearance of scenes on the 1-16 led display ( which
was modified by the mistaken selection operation) and select the new scene.
If at step 1 a programmed scene is selected , it is possible to:
cancel it keeping the DELETE key pressed until the relative led is lighted on.
copy it in another scene pressing the COPY key and choosing afterwards the
destined scene with the 1-16 keys.After press the ENTER key until the relative
led is lighted on to complete the procedure that memorises the copied scene and
contemporarily advances it.
At the conclusion of both procedures, the MASTER 816 will always go back to
step 2 position.
After completing the modifying / programming of the desired game scenes,
pressing the GAME key you exit the programming scene and you go back to
step 2 of the GAME modality and the new game just created is executed.
It is possible to select 3 ways of advancing the scenes:AUTOMATIC,
INTERNALMUSICAL(by an incorporated microphone ) and EXTERNAL
MUSICAL(with RCAcurrent tap on the posterior).
The selection is done keeping the TRIGGER key pressed until the trigger is
changed itself. The led placed on the TRIGGER key shows all the ways of
advancing the scenes.
InAUTO modality, the interval between the advancement of one scene and
the next can be imposed with the slider PAUSE: the values imposed go from
a minimum of 150ms(400beats/min) to a maximum of about 60 seconds
(1beat/min).
Instead with the slider SPEED it is possible to regulate the speed of the moving
PAN and TILT within the limits imposed by PAUSE.
The controller MASTER 816 can send a reset signal to the DTS projectors
connected to it. To enable this function press contemporarily the DELETE
key and the SCANNER key until the two relative leds start flashing.
At this point with the 1-16 keys select the projectors to reset: the reset command
is activated pressing the ENTER key until the relative led is lighted on.
The reset function has the most priority, therefor it can be activated in any
Moment.
TRIGGER CHANGE AND SPEED AND PAUSE REGULATION.
RESET FUNCTION OF THE PROJECTORS
To Next Page
Loading...
Need help?
General